Catia v5r21 lines are white software#

While using SLOT, I have used the same guide curve that was used for RIB. SLOT removes the material along a guide curve. RIB is used to make components like springs, pipes etc. This command which is usually known as SWEEP is called RIB IN CATIA. It requires an axis, around which the sketch will be revolved. It is Like revolve command in other CAD software, the SHAFT command is mostly used to make shaft like parts. On the figure below the POCKET command is helping to create the cylinder hole in the middle of the cube. It simply helps remove geometry belonging to an already create part. The POCKET commands somehow the opposite of PAD command. This command adds material in the third direction, a direction other than the sketch.

In most CAD software, the equivalent of this is called EXTRUDE, but in CATIA we call it PAD. Some of the commands in workbench explained below Part design environment is used to create 3D models from the basic 2D sketches created in sketcher environment.

Sketch tools toolbar: The commands in this toolbar allow you to work in different modes which make sketching easier.

Constraint toolbar: Profiles may be constrained with dimensional (distances, angles, etc.) or geometrical (tangent, parallel, etc.) constraints using the commands located in the Constraint toolbar.

Operation toolbar: Once a profile has been created, it can be modified using commands such as trim, mirror, chamfer, and other commands located in the Operation toolbar.

Profile toolbar: The commands located in this toolbar allow you to create simple geometries (rectangle, circle, line, etc.) and more complex geometries (profile, spline, etc.).The Sketcher workbench contains the following standard workbench specific toolbars. To exit the sketcher, select the Exit Workbench icon. You can choose this plane either before or after you select the Sketcher icon. When you enter the sketcher, CATIA requires that you choose a plane to sketch on. Two simple ways are by using the top pull down menu (Start вЂ“ Mechanical Design вЂ“ Sketcher), or by selecting the Sketcher icon. You can access the Sketcher workbench in many ways. Features (pads, pockets, shafts, etc.) may then be created solids or modifications to solids using these 2D profiles. The Sketcher workbench is a set of tools that helps you create and constrain 2D geometries. The use of Product Data Management (PDM) systems can store the whole design and processing history of a certain product, for future reuse and upgrade.Д¬ATIAВ (an acronymВ of computer aided three-dimensional interactive application) developed by the French company Dassault SystГЁmes. Record and recall information with consistency and speed. Implementing Finite Elements Analysis methods, the user can perform:В Static, Dynamic and Natural Frequency analysis, Heat transfer analysis, Plastic analysis, Fluid flow analysis, Motion analysis, Tolerance analysis, Design optimization. Perform complex design analysis in short time. The user can nearly view the actual product on screen, make any modifications to it, and present his/her ideas on screen without any prototype, especially during the early stages of the design process. The role of the CAD is in aiding him/her by providing:ДЄccurately generated and easily modifiable graphical representation of the product. The core of a CAD system is the S/W, which makes use of graphics for product representation databases for storing the product model and drives the peripherals for product presentation it does not change the nature of the design process but as the name states it aids the product designer.

Catia v5r21 lines are white software#

A CAD system consists of IT hardware (H/W), specialized software (S/W) (depending on the area of application) and peripherals, which in certain applications are quite specialized. This will list general toolbars used in each modules and there overview for academic purpose with some specific topic elaborations.Д¬omputer Aided Design-CAD is defined the use of information technology (IT) in the Design process. This tutorial contains Basic Catia modules sketcher, part, assemblies, drafting.